1、Autocontrol of parameters of bending tube by MF induction heating
中頻熱推彎管工藝參數自動控制

2、An autocontrol scheme for MCS 51 microcontroller was designed for fiberboard hot press control.
本文提出了一種用MCS -51單片機對纖維板熱壓機進行自動控制的設計方案。

3、The hardware and software of autocontrol system were also discussed in detail.
壁焊機自動控制系統的硬件組成和軟件實現。

4、So can implement the whole autocontrol of drainage system.
從而實現對排水系統的全自動控制。

5、Autocontrol Diesel Online Emulsification System Based on AVR MCU
基于A(yíng)VR單片機的柴油機油-水在線乳化自控系統

6、This paper presents the principle, hardware and software design of VB6.0-Based autocontrol system.
介紹了一種基于VB6.0的硫化控制系統原理、硬件和軟件設計。

7、Autocontrol of Cannon Shot Number During the Shooting Test of Servo System
火炮隨動系統射擊試驗射彈數的自動控制

autocontrol翻譯