1、Check the electroplating process, timely adjust equipment and system to provide.
檢查電鍍流程，適時調整設備和制具。

2、Electroplating machine USES urethane rubber rollers featuring smooth travel without noise.
電鍍機滾輪采用聚氨酯橡膠，行走平穩無噪音。

3、Study on dropwise condensation heat transfer on composite electroplating surface;
蒸汽冷凝傳熱中，不凝氣的存在嚴重惡化其傳熱過程。

4、The modification electroplating position, pay attention to the current distribution line.
重新修正電鍍位置，注意電流分布線。

5、STUDY ON ELECTROPLATING OF HIGH-LEVELLING AND FULL BRIGHT Ni-Fe ALLOY
高整平全光亮鎳鐵合金電鍍的研究

6、The chromium deposition velocity of trivalent chromium electroplating was researched.
對三價鉻電解液鍍鉻的沉積速度進行了實驗研究。

7、Electroplating of Copper From HEDP Bath Using CuR-1 Additive
應用CuR-1型添加劑的HEDP鍍銅新工藝

8、Study on the electroplating technology of solderable bright Sn-Bi alloy
可焊性光亮錫鉍合金電鍍工藝研究

9、Electroplating time mixing effect is bad.
電鍍時間攪拌效果不良。

10、Whet her electroplating quality is good or bad depends on pre-treatment.
鋁制件電鍍質量的好壞，預處理是關鍵。

11、We want to buy Buffing Compounds, Electro, Lustre, Metal Rouge, Electroplating Metals and alloys.
我們要采購擦光化合物，電鍍物品，光彩，金屬口紅，電渡金屬和合金。

12、Bright Sn-Bi Alloy Electroplating Technology
電鍍光亮錫鉍合金工藝研究

13、The sign of electroplating is completed, will cut off the excess of semi-finished products.
標牌電鍍完畢后，還要將半成品上的余量切掉。

14、Inside-holding electroplating process is a precise technique in producing diamond reamer.
利用內鍍方法制造金剛石鉸刀是一種精密鉸刀制造方法。

15、Study on the Electroplating Technology of Solderable Bright Sn-Sb Alloy
可焊性光亮錫銻合金電鍍工藝研究

16、Serious when, electroplating cannot proceed.
嚴重時﹐電鍍不能正常進行。

17、Wuhan fengfan electroplating technology co. ltd.
武漢風帆電鍍技術有限公司。

18、The effects of ultrasonic on the tin-bismuth alloy electroplating are studied.
研究了超聲波對錫鉍合金電鍍的影響。

19、A process of Cr electroplating at room temperature with low chromic anhydride content was proposed.
提出了一種常溫低濃度鍍鉻工藝。

20、The major advantages and disadvantages of trivalent chromium electroplating were introduced.
介紹了三價鉻鍍鉻的主要優點與缺點。

21、Electroplating mixing potions, uneven circulation or metal added less than consumption.
電鍍藥水?dāng)嚢瑁?a href="/zaoju/e4499.htm">循環不均或金屬補充不及消耗。

22、A BRIGHT CITRATE Sn-Zn ALLOY ELECTROPLATING PROCESS
檸檬酸鹽電鍍光亮錫鋅合金工藝

23、Bright Chloried Zn-Fe Alloy Electroplating and Its Application
氯化物全光亮鋅鐵合金電鍍工藝及應用

24、As the pores exist, the result of electroplating the ferrous powder metallurgic parts is very bad.
由于孔隙的存在，鐵基粉末冶金零件的電鍍效果均不理想。

25、Tin - bismuth alloy was electroplating by electrodepositing associated with ultrasonic agitation.
將超聲和電沉積相結合電鍍了錫鉍合金。

26、The current problems existing in the non-cyanide electroplating production were presented.
指出了當前電鍍生產無氰化過程中存在的問題。

27、Industrial use of ruthenium electroplating was indicated.
說明了釕電鍍的工業用途。

28、The history of trivalent chromium electroplating was looked back.
回顧了三價鉻鍍鉻的歷史。

29、Yet electroplating does not work on silicon either.
但是矽還是無法電鍍。

electroplating翻譯