1、Analysis for punching shear failures character of thick flat raft foundation.
童雄，厚平筏板基礎沖切破壞性能研究。

2、However, further increasing of re content would degrade the shear properties of the lap joint.
而當稀土含量進一步增加時，焊點的強度及塑性均下降。

3、And osteoblast is most sensitive to shear stress.
其中成骨細胞對剪切應力最敏感。

4、Analysis of shear lag effect in prestressed RPC simply-supported box girder
RPC預應力簡支箱梁剪力滯效應分析

5、The extensional simple shear model of the Chagan fault depression is established.
建立了查干凹陷發育的簡單剪切模式。

6、Characteristic Wave of Meso-β Scale Disturbance in Shear Basic Flow
切變基流中β中尺度擾動的特征波動

7、To concrete shear walls, they add steel braces to a skyscraper's skeleton or beefier rebar.
為了用混凝土覆蓋剪力墻，他們把鋼托支撐加到摩天大樓的骨架或是大鋼筋上。

8、At lower shear rate, the fluid viscosity of composite has more sensitiveness to temperature.
在較低的剪切速率下，復合材料流體粘度對溫度更敏感。

9、The principle of imaging system for laser electron shear speckle interferometry is presented.
介紹了激光電子剪切散斑干涉成像系統的原理；

10、Then axil shear tractive force of the whole structure of imitate bridge was measured in each.
然后，按照隨機的順序，對模擬的金屬翼板粘結橋模型逐一進行了整體結構的軸向剪切拉力測試。

11、Shear Angle research is one of the basic problems in metal cutting theory.
剪切角的研究是金屬切削理論中的一個基本問題。

12、EARTHQUAKE RESPONSE OF R/C FLAT PLATE-COLUMN WITH SHEAR WALL STRUCTURES
鋼筋混凝土板柱-剪力墻結構的地震反應

13、A Kuka robot with 2,200-pound payload capacity places material blanks onto the shear load table.
一個負重能力為1000公斤的庫卡機器人正在把板料裝載到剪板機的工作臺上。

14、Shear lag is reduced for prestress in serviceability limit state.
在正常使用狀態下，預應力平抑了箱梁剪力滯效應。

15、When the shear line vapour band is weak, and the Plateau shear line will move southeastward.
切變線水汽帶減弱時，高原切變線東南移。

16、(4)the static yield shear angle may be a fixed value as 206 degree
靜態剪切屈服角基本上是一個206度的定值。

17、Influence of Molecular Structure of OCP VI Improveron shear Stability
OCP粘度指數改進劑分子結構對剪切安定性能的影響

18、Shear force is interrelating with width and thickness of plate and obliquity of knife-edge.
斜刃剪切時，剪切力的大小與板料的寬度、厚度及斜刃傾角有關。

19、Adopting lever feed mode to shear cloth.
采用杠桿推進方式裁切布料。

20、As compared with Shear Type KR Vessel, FWACTV raises the efficiency of agitated mixing.
與“剪切型”的KR法相比，這種反應器提高了混合效率。

21、Effect of Shear Rate,NO and ET on Atherosclerosis of Carotid Artery
一氧化氮、內皮素與血流剪切率在頸動脈粥樣硬化斑塊形成中的作用

22、Test Study of Shear Lag Effect in Model of a PPC Box Girder Segment
PPC箱梁節段模型剪滯效應的試驗研究

23、A jam occurred in a 603 scroll shear which covered the hopper sensor
603號曲線剪發生了卡罐現象，蓋住了送料斗的感應器。

24、Shear Strength of Sandy-gravels in Shitouhe River Dam
石頭河土石壩砂卵石抗剪強度

25、The subhorizontal shear zone exists in the deep structural level.
在深部構造層次上表現為近水平的韌性剪切帶。

26、The shear strength and elongation of the lap joint increase with the increase of strain rate.
焊點的剪切強度及伸長量隨應變速率的增加而增加。

27、The shear strength of BGA joint with eutectic solder is higher than that of tin-lead alloy itself.
共晶釬料BGA球焊點的抗剪強度比錫鉛合金釬料自身的抗剪強度大。

28、Instabilitable Computation Method of Shear Flow of Johnson-Segalman
Johnson-Segalman流體剪切流動中不穩定現象數值計算

29、Analysis of Shear Lag Effect of Continuous Rigid Frame Bridges
連續剛構橋的剪力滯效應分析

30、The shear displacement for the dilatation is always less than that at the peak shear stress.
剪應力達到峰值所需要剪位移總是比剪脹發生時所需的剪位移大。

shear翻譯

n. 修剪, 剪下的東西, 大剪刀, 切變, 剪切機, 切vt. 修剪, 割, 剝奪, 橫越, 削剪vi. 剪, 修剪, 剪羊毛, 切斷【化】 剪切; 剪應變 詳情